Fixing Fence Section

Action one: Lower 2x4 rails to fit flat along the tops on the posts. The rails can prolong from post to publish, or even a rail can span two sections. Measure and minimize each rail independently to allow for slight variations in the fence post spacing. Butt the finishes on the rails tightly collectively. Then, starting at one particular conclusion from the fence line, nail rails in position with two 10d galvanized widespread nails at the finishes of every rail.
Phase 2: Measure and minimize the 2x4 base rail to fit snugly concerning just about every pair of posts. Situation the rails flat in between the posts, any where from a little above quality level to 12 inches up. Nail the underside rails into area with a 10d galvanized nail pushed at an angle via the fence post and into the end in the rail on both sides. Make use of a amount to maintain rails even.
Step three: Measure and slash the fence boards. They must be of uniform duration, so long as the gap with the bottom from the bottom rail to the top in the prime rail, as calculated at among the posts. Starting at one finish, nail boards to 1 aspect with the rails, leaving house equal to a single board width amongst every. Protected every board to your rails with two 8d galvanized nails at the top rated and two for the base. Nail tops to start with, flush using the top rated, then nail the bottoms, pulling or pushing the underside rail into alignment when you go. In case your fence may have boards on either side, nail up all of the boards on 1 facet initially, then nail alternate boards to other aspect with the rails, positioning boards to address areas remaining by boards on reverse aspect. ­